Kitchen exhaust cleaning vs hood cleaning: same job or not?
They should be the same job. Too often they are not. What a full kitchen exhaust cleaning covers, what a hood-only job skips, and five questions that tell you which one you are paying for.

Kitchen exhaust cleaning and hood cleaning are supposed to mean the same thing: cleaning the entire exhaust system from the cooktop to the roof. The difference shows up when a company sells "hood cleaning" and only cleans the hood.
The fire code does not care which name is on the invoice. It cares whether the duct and the fan got cleaned. Here is how to tell.
What is a kitchen exhaust system?
Four parts, in the order the smoke travels:
- The hood. The stainless canopy over the line, plus the filters and the grease trough.
- The plenum. The chamber behind the filters. You cannot see it until a filter comes out.
- The duct. The metal run from the hood up through the ceiling and out to the roof. It can go straight up ten feet or sideways sixty.
- The fan. The unit on the roof that pulls it all out.
Grease does not stop at the filters. It rides the hot air and coats everything after them. Our guide on where grease hides in a kitchen exhaust system goes part by part.
What does "hood cleaning" usually mean on a quote?
It depends on who wrote the quote. That is the problem.
From a full-service company, "hood cleaning" is shorthand for the whole system. From a low bidder, it can mean the part you can see from the kitchen floor. The canopy gets polished, the filters get swapped, a sticker goes on. The plenum, the duct, and the fan never get touched.
That job looks finished. The stainless shines. And the fuel is still sitting in the duct.
What does the fire code require?
The whole system. The Oregon Fire Code and NFPA 96 both name hoods, grease-removal devices, fans, ducts, and other appurtenances. Nothing in either one says the hood alone counts.
So when the question is "do I need kitchen exhaust cleaning or hood cleaning," the answer is that the code only recognizes one job, and it goes to the roof. The Oregon rules are laid out in our Oregon fire code guide.
Why does the duct matter more than the hood?
Because that is where a kitchen fire becomes a building fire.
A flare-up on the line is common. The suppression system is there for it. The trouble starts when flame gets pulled past the filters into a duct lined with grease. Now the fire is inside the walls and headed for the roof, where nobody on the line can reach it.
A clean hood under a dirty duct is a kitchen that passes a glance and fails a fire.
How do you tell which job you got?
Ask for the photos. A crew that cleaned the duct and the fan has pictures of the duct and the fan, before and after. A crew that did not has pictures of a shiny hood.
Then check three things yourself:
- Pull a filter. Look at the plenum behind it. Bare metal means it was cleaned. A brown film means it was not.
- Read the report. A real report lists any section that could not be reached and why.
- Ask about the roof. Did someone go up? Was the fan tipped open and cleaned inside?
Five questions to ask before you book
- Do you clean the duct and the rooftop fan every visit, or only the hood?
- Do I get before and after photos of the plenum, the duct, and the fan?
- Does the report list areas you could not reach?
- Are your technicians certified, and will my fire department accept it?
- What happens if there is no access panel on a long duct run?
That last one matters. If a duct has no access, part of it cannot be cleaned by anyone. The fix is an access panel, and an honest company tells you that instead of skipping the section quietly.
Why is one quote half the price of another?
Usually because it is half the job. Cleaning a duct and a rooftop fan takes a second crew member, more time, and a trip to the roof at night. A price that leaves no room for that is telling you what is included.
What a full job should cost in this region is in our hood cleaning cost guide.
Frequently asked questions
Is kitchen exhaust cleaning the same as hood cleaning?
It should be. Both names are used for cleaning the full exhaust system: hood, filters, plenum, duct, and rooftop fan. Some companies sell hood cleaning that only covers the visible hood, which does not meet the fire code.
Does hood cleaning include the ducts?
A code-compliant job does. The fire code and NFPA 96 require hoods, grease-removal devices, fans, and ducts to be cleaned. Ask for photos of the duct and fan to confirm.
How do I know if my ducts were actually cleaned?
Ask for before and after photos of the duct and the rooftop fan, pull a filter and look at the plenum, and read the report for any areas listed as not cleaned.
What is the plenum?
The chamber behind the hood filters where the exhaust air collects before it enters the duct. It is hidden until a filter is removed, and it is the first place an inspector looks.
Want the whole system cleaned, with the photos to prove it? Get a free estimate or call (800) 973-5573 any hour.
